Printers
Printronix T800
Printronix T4000
Printronix T6000e
Zebra ZD500R
ZD500R: Reset to Factory Defaults
Turn off the printer using the switch on the back. Press and hold FEED + PAUSE while turning on t...
ZD500R: Calibrate from Printer's Interface
Step 1: Media CalibrationHold the PAUSE + CANCEL buttons for 2 seconds to start the media calibra...
ZD500R: Alignment
Adjusting the vertical print position on your labelsFrom the main screen, press the Home button (...
Zebra ZD621R
Zebra ZD621R: Alignment
Select Menu from the home screenSelect the Print iconSelect Label Position/Image Adjust Select Ve...
Zebra ZD621R: Reset to Factory Defaults
After starting the printer, use the touchscreen to click "Menu"On the left side of the screen, cl...
Zebra ZD621R: Calibrate from Printer's Interface
Step 1: Media CalibrationFirst, make sure media is properly loaded, the printer cover is closed, ...
Zebra ZT411
Zebra ZT410
Printronix: Calibration
Note: Before proceeding with calibration, it is best practice to ensure the onboard RAM is cleare...
Printronix: Alignment
Step 1:Pause your printer using the green Pause buttonUsing the arrow and enter keys, navigate to...
Printronix: Darkness
If using wax ribbon, we recommend your darkness is set between 0 and 5.If using resin ribbon, we ...
Printronix: GAP NOT DETECTED
A “GAP NOT DETECTED” error means that the printer was not able to find the gap/mark between label...
Printronix: Connecting to Wi-Fi
If you purchased a Printronix printer with Wi-Fi capabilities, follow these instructions to conne...
Printronix: Check Firmware Version
From the web portal, click the Available Printers menu.Locate your printer, then click the Settin...
Printronix: Update Firmware
To update the firmware on your Printronix printer, it must be connected to your network. The USB ...
Printronix: Job in Process
Printronix printers often state "Job in Process" (often misread as "Job in Progress") on their sc...
Printronix: ENTER SWITCH LOCKED
Printronix printers lock the Enter switch to prevent accidental changes to settings. If you see t...