Printer Profile: Calibrate Printer from web

The printer profile page contains details for each connected printer. Users can navigate to this page from the Available Printers pop-out menu, or the Station Settings

Printer Profile Details

• Location the printer is connected to
• 'Station' (Host PC) the printer is connected to
• Serial Number of the Printer
• Firmware Version of the Printer
• Date the printer was setup
• Printer DPI: 203, 300, or 600
• Connection Method: USB or Ethernet
• Print Station connectivity indicator
• Printer connectivity indicator
• Notes section
• Calibrate Printer button
• Save button to save changes
• Close button to exit the page

Calibrate Printer from Printer Profile

• Calibrate click the button
• Click 'Calibrate' on pop-up

• Accepting this prompt will then send both the media and ribbon and RFID calibrations to the printer, which will proceed automatically with the following steps:
  • Media and Ribbon.
  • Then a pause for roughly 10 seconds.
  • And then the RF calibration, which will take longer; the labels will periodically inch out of the printer for approximately one minute. At the end of the process it will feed out 2 or 3 labels before stopping completely.
• After the calibration has completed:
  • Open the printer and roll back the labels so the blank tags may be used—precision is not necessary
  • Un-pause the printer
  • Now you are ready to print.

If the printer continues to VOID labels, repeat the process. If the issue persists, perform a calibration directly from the printer itself.