Calibrate from the web portal

Make sure the printer is unpaused before calibrating: Unpause your printer You can calibrate your printer from the web portal. This can be done from three places: Option 1: From the Menu Bar Access the Available Printers icon at the top-right of the page. Locate the desired print station and click the Calibrate icon to the right. Finally, click Calibrate to start the calibration process. Accepting this prompt will then send both the media and ribbon and RFID calibrations to the printer, which will proceed automatically with the following steps: Media and Ribbon. Then a pause for roughly 10 seconds. And then the RF calibration, which will take longer; the labels will periodically inch out of the printer for approximately one minute. At the end of the process it will feed out 2 or 3 labels before stopping completely. After the calibration has completed: Open the printer and roll back the labels so the blank tags may be used—precision is not necessary Un-pause the printer Now you are ready to print. If the printer continues to VOID labels, repeat the process. If the issue persists, perform a calibration directly from the printer itself. Option 2: From the printer's Printer Profile page The printer profile page contains details for each connected printer. Users can navigate to this page from the Available Printers pop-out menu, or the Station Settings Printer Profile Details Location the printer is connected to 'Station' (Host PC) the printer is connected to Serial Number of the Printer Firmware Version of the Printer Date the printer was setup Printer DPI: 203, 300, or 600 Connection Method: USB or Ethernet Print Station connectivity indicator Printer connectivity indicator Notes section Calibrate Printer button Save button to save changes Close button to exit the page Calibrate Printer from Printer Profile Calibrate click the button Click 'Calibrate' on pop-up Accepting this prompt will then send both the media and ribbon and RFID calibrations to the printer, which will proceed automatically with the following steps: Media and Ribbon. Then a pause for roughly 10 seconds. And then the RF calibration, which will take longer; the labels will periodically inch out of the printer for approximately one minute. At the end of the process it will feed out 2 or 3 labels before stopping completely. After the calibration has completed: Open the printer and roll back the labels so the blank tags may be used—precision is not necessary Un-pause the printer Now you are ready to print. If the printer continues to VOID labels, repeat the process. If the issue persists, perform a calibration directly from the printer itself. Option 3: From the Printer Station Settings This page allows for the assignment and view of all printers including settings.